Other Jetztrim Products

Gaskets

We have gaskets for every trim ring we sell.

Some installations will also need an extra thick gasket to raise the mounting surface under our stainless steel shifter plate. We've got you covered there, too, with our 5mm shimming gaskets. They'll give your assembly the tight seal it needs.

Standard Gaskets

Prefer to install your shifter plate over the boot and with the trim ring on top?

No Problem ... But  you'll want to prevent scratches

by using this standard gasket between ring and plate.

Please Choose Your Truck Make

5mm Gaskets

Is your carpet or floor mat so thick and cushiony that your trim ring is sunk down into it? Our stainless steel shifter plates need to have uniform and level contact across the mat underneath.

This extra thick (5 mm) rubber gasket should do the trick. It will shim up the depressed mounting surface so that it makes a uniform surface beneath your shifter plate.

Make sure the assembly has a tight, secure seal to the cab floor or mat as per your truck manufacturer's intentions.

Please Choose Your Truck Make

Universal Hardware Kit for Shift Boot Trim Rings & Shifter Plates.

Give your shifter assembly the finishing touch with our 24-piece hardware kit.
Kit comes with:

(8) #10 x 1" screws
(8) electroplated plastic screw caps
(8) washers.

Please Choose Your Truck Make